This topic has 0 replies, 1 voice, and was last updated 2 years, 3 months ago by 
.
-
Posts
-
Hello fellow scenic artists! We are painting 4’x8′ plastic Vacuform brick panels that will be installed on an outdoor set. On past productions, the carpenters used spray foam for the seams. It was very labour intensive carving it to clean it up. We’re not sure that caulking is a good solution either- it might not conceal hard edges. Any suggestions out there? Thanks!
Viewing 1 post (of 1 total)
You must be logged in to reply to this topic.
