This topic has 1 reply, 2 voices, and was last updated 2 years, 7 months ago by EvanWRapp. Author Posts March 6, 2019 at 2:38 am #14949 Scott GerwitzAdmin Experience: 20+ yearsScenic Status: Full Time RegularPartner I have to dull a piece of acrylic plexi that is going to be covering a large hole in the deck. I usually spray an acrylic poly to achieve this. But that does not hold up to foot traffic. I never had anyone walk on the windows. Anyone have some other solutions that would hold up for a floor? Cheers Scott Sent from my iPhone using Tapatalk March 7, 2019 at 8:53 pm #15904 EvanWRapp Experience: 5-10 yearsScenic Status: Full Time Regular Thinner? Not sure if the material you are talking about is the same as what I am thinking. However, I used to flame polish acrylic edges and found out the hard way that denatured alcohol cleans well but acetone will cloud the surface just a bit. What about a light scuff with an abrasive pad? Author Posts Viewing 2 posts - 1 through 2 (of 2 total) You must be logged in to reply to this topic.